Difference between revisions of "Parts not supplied by Dynon"

From DynonDocs
Jump to: navigation, search
 
(17 intermediate revisions by 5 users not shown)
Line 1: Line 1:
Contacts
+
Dynon Avionics supplies various parts, accessories, and sensors support the installation of its instruments. Many common, small parts - connectors, resistors, etc. are included in kits supplied with specific units and sensors. The complete list of all products available directly from Dynon Avionics is at [http://www.dynonavionics.com/downloads/order_form.pdf http://www.dynonavionics.com/downloads/order_form.pdf].
----
+
 
 +
But there are some parts that Dynon Avionics does not supply, due to the wide range of installation options available for various aircraft types and installations.
  
 +
Dynon created this dynamic Parts documentation wiki that customers are invited and encouraged to help maintain, update, and enhance. Please contribute your favorite parts and suppliers that made your installation of Dynon instruments easier, faster, safer, less expensive, and more reliable.
  
Switches
+
'''Autopilot-related Parts'''
 
----
 
----
 +
* '''AP Disengage/Control Wheel Steering (CWS) Button''' - A push button is required for installation of the Dynon Autopilot (AP) to disengage the AP or to engage the AP in Control Wheel Steering (CWS) mode. It may be desirable to locate this button on the yoke instead of the panel.
 +
** Specification: Push Button Single Pole Normally Open (PB SP NO), minimum current rating 1 Amp (1A).
 +
** Example (for mounting on panel) - Aircraft Spruce P/N 11-00748.
 +
 +
* '''AP74/HS34 Audio Level Adjustment Potentiometer''' - A variable resistor (potentiometer) is required to connect the audio output of the (AP74 {and HS34} into the aircraft's audio system. This potentiometer is typically only adjusted once, so we recommend that the potentiometer have a "short shaft" so that it can be tucked up under the panel, adjusted with a screwdriver, and then only rarely accessed.
 +
** Specification: Potentiometer with a short shaft, screwdriver slot, 10 Kilo Ohm (10 Kohm), 1/2 watt
 +
** Example - Radio Shack P/N 271-1715
  
* '''AP Servo Power Switch/Circuit Breaker''' - Minimum current rating 6 Amp (6A); example - [http://www.aircraftspruce.com Aircraft Spruce] P/N 11-04122 (7.5A)
 
  
* '''AP Disengage/Control Wheel Steering (CWS) Button''' - Push Button Single Pole Normally Open (PB SP NO); Minimum current rating 1 Amp (1A); example - [http://www.aircraftspruce.com Aircraft Spruce] P/N 11-00748
+
'''EFIS-related Parts (EFIS-D10A, EFIS-D100, FlightDEK-D180)'''
 +
----
 +
* '''1/4" Inside Diameter Pneumatic Tubing (including adapters, clamps, etc.)''' - Required for connecting, routing, and securing pneumatic lines between Dynon EFIS pressure sensor ports and external ports.
 +
** Specification:
 +
** Example:  
  
  
Resistors
+
'''EMS-related Parts (EMS-D10, EMS-D120, FlightDEK-D180)'''
 
----
 
----
 +
* Differential fuel flow computers for engines with return fuel lines (EMS-D10/D120 and FlightDEK-D180 only. SkyView has this capability natively)
 +
** Matronics Fuel Flow Computer
 +
*** Description: The RFC is used in applications where some portion of the fuel flowing through the line is returned directly back to the fuel tank.
 +
**** Website: http://www.matronics.com/fuelchec/RFC/index.htm
 +
** EI FFDM-1 Fuel Flow Diferential Module
 +
*** Available from:
 +
**** http://www.aircraftspruce.com/catalog/inpages/ei-fuelflowpressure.php
 +
**** http://www.chiefaircraft.com/ei-ffdm-1.html
 +
* Contacts - Dynon Avionics does not sell contacts.
 +
** Specification:
 +
** Example:
 +
* Fuel Level sensor - Dynon Avionics does not sell fuel level sensors.
 +
** Specification:
 +
** Example:
 +
* Flap Position sensor - Dynon Avionics does not sell flap position sensors.
 +
** Specification:
 +
** Example:
 +
* Indicator light - Dynon Avionics does not sell indicator lights.
 +
** Specification:
 +
** Example:
 +
* Switches - Dynon Avionics does not sell switches.
 +
** Specification:
 +
** Example:
 +
* Tachometer transducer - Dynon Avionics does not sell tachometer transducers.
 +
** Specification:
 +
** Example:
 +
* Trim Position sensor - Dynon Avionics does not sell trim position sensors.
 +
** Specification:
 +
** Example:
  
* '''AP74/HS34 Audio Adjustment Potentiometer''' - 10 Kilo Ohm variable resistor (potentiometer); short shaft/screwdriver (rather than knob) adjustment
+
'''Dynon Transponder related Parts'''
 +
----
 +
* '''TNC Connector''' - Connector for Dynon Transponder
 +
** Specification: Dual Crimp RG142-400 AMP Male
 +
** Example: http://www.aircraftspruce.com/catalog/elpages/edmo2255556.php
 +
* '''Transponder Antenna'''
 +
** Specification: Comant CI-105 Family, TED or CI-101, For composite an internal dipole works.
 +
**Example:
  
* '''AP Disengage/Control Wheel Steering Button (CWS) Broken Line Detection Resistor''' - 5 Kilo Ohm (5K ohm), 10% tolerance, 1/2 watt power rating
 
* '''Rotax P/N 956413 Oil Pressure Sensor Resistor''' - 200 Ohm, 10% tolerance, 1/2 watt power rating
 
  
  
Connectors
+
'''Common Parts'''
 
----
 
----
* '''Butt Splices''' - accommodate various wire diameters (various barrel colors)
+
* '''Adel Clamps ''' - Required for mounting of various Dynon engine sensors.
* '''Faston''' - accommodate various wire diameters (various barrel colors)
+
** Specification: various diameters  
* '''Ring Terminals #8"''' - accommodate various wire diameters (various barrel colors
+
** Example:
* '''Ring Terminals #10"''' - accommodate various wire diameters (various barrel colors
 
  
 +
* '''Crimp Connector Selection''' - Kit of various crimp-on connectors.
 +
** Specification: Includes Butt Splice, FastOn, Ring Terminals
 +
** Example:
  
Cable/Wiring/Tubing
+
* '''Crush Washer''' - Required for installing Dynon Oil Temperature sensors.
----
+
** Specification: 1/8", 5/8", AN900-10
* '''1/4" Inside Diameter Pneumatic Tubing''' -  
+
** Example: [http://www.aircraftspruce.com/catalog/eppages/epan900.php]
* '''22 AWG Wire''' -  
+
 
* '''J Type Thermocouple Wire''' -  
+
* '''Resistor Selection''' - Kit of various resistors.
* '''K Type Thermocouple Wire''' -
+
** Specification: 10% minimum tolerance, 1/2 watt power rating minimum
* '''Shielded Cable''' -
+
** Example:
  
 +
* '''Teflon Tape''' - Required for installing various Dynon engine sensors.
 +
** Specification:
 +
** Example:
  
 +
* '''Wire Selection''' - Kit of various colors of wire.
 +
** Specification: 22 AWG
 +
** Example:
  
Misc.
+
'''Vendors'''
 
----
 
----
* '''Adapters, clamps, etc.''' For Routing/Securing 1/4" ID Pneumatic Tubing -  
+
* [http://www.aircraftspruce.com Aircraft Spruce - www.aircraftspruce.com] 877-477-2783 / 951-372-9555
* '''Adel clamps''' Various Diameters For Securing Engine Sensors -  
+
* [http://www.radioshack.com Radio Shack - www.radioshack.com] 800-843-7422
* '''Crush Washer (1/8")''' For Oil Temperature Sensor Dynon P/N 100409-000
 
* '''Crush Washer (5/8")''' For Oil Temperature Sensor Dynon P/N 100409-001
 
* '''Teflon Tape''' -
 

Latest revision as of 16:28, 8 May 2012

Dynon Avionics supplies various parts, accessories, and sensors support the installation of its instruments. Many common, small parts - connectors, resistors, etc. are included in kits supplied with specific units and sensors. The complete list of all products available directly from Dynon Avionics is at http://www.dynonavionics.com/downloads/order_form.pdf.

But there are some parts that Dynon Avionics does not supply, due to the wide range of installation options available for various aircraft types and installations.

Dynon created this dynamic Parts documentation wiki that customers are invited and encouraged to help maintain, update, and enhance. Please contribute your favorite parts and suppliers that made your installation of Dynon instruments easier, faster, safer, less expensive, and more reliable.

Autopilot-related Parts


  • AP Disengage/Control Wheel Steering (CWS) Button - A push button is required for installation of the Dynon Autopilot (AP) to disengage the AP or to engage the AP in Control Wheel Steering (CWS) mode. It may be desirable to locate this button on the yoke instead of the panel.
    • Specification: Push Button Single Pole Normally Open (PB SP NO), minimum current rating 1 Amp (1A).
    • Example (for mounting on panel) - Aircraft Spruce P/N 11-00748.
  • AP74/HS34 Audio Level Adjustment Potentiometer - A variable resistor (potentiometer) is required to connect the audio output of the (AP74 {and HS34} into the aircraft's audio system. This potentiometer is typically only adjusted once, so we recommend that the potentiometer have a "short shaft" so that it can be tucked up under the panel, adjusted with a screwdriver, and then only rarely accessed.
    • Specification: Potentiometer with a short shaft, screwdriver slot, 10 Kilo Ohm (10 Kohm), 1/2 watt
    • Example - Radio Shack P/N 271-1715


EFIS-related Parts (EFIS-D10A, EFIS-D100, FlightDEK-D180)


  • 1/4" Inside Diameter Pneumatic Tubing (including adapters, clamps, etc.) - Required for connecting, routing, and securing pneumatic lines between Dynon EFIS pressure sensor ports and external ports.
    • Specification:
    • Example:


EMS-related Parts (EMS-D10, EMS-D120, FlightDEK-D180)


  • Differential fuel flow computers for engines with return fuel lines (EMS-D10/D120 and FlightDEK-D180 only. SkyView has this capability natively)
  • Contacts - Dynon Avionics does not sell contacts.
    • Specification:
    • Example:
  • Fuel Level sensor - Dynon Avionics does not sell fuel level sensors.
    • Specification:
    • Example:
  • Flap Position sensor - Dynon Avionics does not sell flap position sensors.
    • Specification:
    • Example:
  • Indicator light - Dynon Avionics does not sell indicator lights.
    • Specification:
    • Example:
  • Switches - Dynon Avionics does not sell switches.
    • Specification:
    • Example:
  • Tachometer transducer - Dynon Avionics does not sell tachometer transducers.
    • Specification:
    • Example:
  • Trim Position sensor - Dynon Avionics does not sell trim position sensors.
    • Specification:
    • Example:

Dynon Transponder related Parts



Common Parts


  • Adel Clamps - Required for mounting of various Dynon engine sensors.
    • Specification: various diameters
    • Example:
  • Crimp Connector Selection - Kit of various crimp-on connectors.
    • Specification: Includes Butt Splice, FastOn, Ring Terminals
    • Example:
  • Crush Washer - Required for installing Dynon Oil Temperature sensors.
    • Specification: 1/8", 5/8", AN900-10
    • Example: [1]
  • Resistor Selection - Kit of various resistors.
    • Specification: 10% minimum tolerance, 1/2 watt power rating minimum
    • Example:
  • Teflon Tape - Required for installing various Dynon engine sensors.
    • Specification:
    • Example:
  • Wire Selection - Kit of various colors of wire.
    • Specification: 22 AWG
    • Example:

Vendors