3rd Party Accessories not supplied by Dynon

From DynonDocs
Revision as of 13:15, 27 August 2013 by Admin (talk | contribs) (Added "TNC to BNC Adapter")
Jump to: navigation, search

Dynon Avionics makes no representations or endorsements of the products found on this page

Ethernet Switch

For customers that install 3 SkyView displays

Contemporary Controls BAS Switch; Available from:


Multi-channel audio mixers

For customers that need to mix in different audio alarms / music / etc to a single input.

Pitot Tube Mounting Bracket Kit

Pitot Tube Mounting Bracket Kits Paintable.jpg

Angle of Attack (AOA) / Pitot / Static Pneumatic Lines

SafeAir1 AOA-Pitot-Static Air Kits PSA Kit SkyView 08.jpg

Remote Angle of Attack Display

VX-Aviation Remote LED AOA Display ADS-horizontal.jpg

Remote Magnetometer (Compass) Mount

SafeAir1 Remote Compass Mount for EDC-D10A RCmount 05.jpg

RPM Signal Voltage Adapter

Useful for adapting a "ECU" (engine control unit) low-voltage (typically, 5V) tachometer signal to a level that can be detected by a Dynon EMS-D10, EMS-D120, or FlightDEK-D180, which require a tachometer signal > 10V.

Baker Electronix TSD/ATSD (Tachometer Adapter) DSC00056r.jpg

Tachometer Generator

Useful for when tapping the P-Lead or other existing signals on an engine isn't applicable. This unit has been verified to work by several customers.

Van's Aircraft P/N IE VTACHGEN 2

24V to 12V DC-DC Converter 10A

Dynon heated pitot tube controller requires 10-15V power input. This unit converts 24V to 12V with minimal power loss.

This unit is only needed for 24V aircraft.

24-12V DC-DC Converter 10AJaycar mp3061.jpg

TNC to BNC Adapter

Dynon's SV-XPNDR-261 and -262 transponders have a TNC connector. But, BNC connectors are more common for preassembled transponder antenna / coaxial cable assemblies than the TNC connector, so here is an adapter that converts TNC to BNC.

TNC to BNC Adapter242149 sml.jpg